Articles on: Spartoo (Shopify)

Connect Spartoo and the app - Spartoo (Shopify)

Your Spartoo settings, rules, product feed, and orders are in Feed.biz. The Shopify app stays installed on the shop. It reads the catalogue and creates the orders. You connect each shop once.


Steps


  1. Open the Spartoo app in your Shopify admin. The screen asks you to connect.


Connect to Feed.biz


  1. Click Connect to Feed.biz. A window opens on Feed.biz. If it does not open, allow pop-ups for the page and click the button again.
  2. Sign in to Feed.biz, or create an account. The window then returns to the confirmation screen.
  3. Feed.biz asks Connect this shop to your Feed.biz account? and shows the Shop and the Connector address. Check both. The notice says: Check the shop and address above before you continue. Feed.biz will read products and stock from this address, and send orders back to it. Then click Connect.


Connect this shop to your Feed.biz account


If this account already has a shop, the window asks This account already has a connected shop. Where should this one go?


  • Add it as a new shop (recommended): its settings, rules and orders stay separate.
  • Replace the connection of the shop, then the shop name. Its products are replaced by this shop's on the next sync.


If this same shop is already connected, the window says This shop is already connected as, then the shop name, and Its connection will be renewed.


  1. The window then shows the shop name and is connected to Feed.biz. It also says You can close this window and go back to your shop. Close it. Shopify now shows This shop is connected to Feed.biz. Under that: Your products, rules and orders are managed there from now on.


This shop is connected to Feed.biz


  1. In Feed.biz, open Spartoo > Settings > Authentication. Enter your Partner code, click Check connection, then Save. The article Settings > Authentication covers that screen.


Authentication, connector filled in


Partner code accepted


What the connection stores


Feed.biz stores the address of the app on your shop, and a token that allows it to read the shop. The Connector address and Connector token on Authentication are filled in by this connection. You cannot type them.


After that, Feed.biz reads the catalogue on a schedule and sends Spartoo orders to the shop.


If it did not finish


The Feed.biz window shows Try again, and says You can close this window and start again from your shop. Nothing was changed. Start again from step 2.


A link opened by hand, or left unused for too long, is refused with This connection link is incomplete. Please start again from your shop. Go back to Shopify and click Connect to Feed.biz again.


Replacing the token


Connect the shop again from the Shopify app. The old token stops working at once, and Feed.biz cannot read the shop until the new connection is saved. Do this when the token should no longer be used.

Updated on: 13/10/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!